Creality's CR-30 printmill is their first 3D printer with infinitive 3D printing capabilities, thanks to the nylon conveyor belt print surface. Also the nozzle prints at a 45 degrees angle, so 3D prints are being build up without the problem of interfering with previous 'layers'. This not only allows you to keep repeating 3D prints, but also create long 3D prints! This makes mass-production possible in a very efficient manner. Other features include the very strong frame with CoreXY system for the fastest possible printing speed, a filament run-out detection system and resume after power failure function to avoid disaster. The printer comes with special 3D printing software included, so it is ready to go in minutes!
The CR-30 needs some assembly, which can be easily done in the steps provided in the included installation manual. The printer comes with tools required for assembly, as well USB stick and a power cord. Make sure to include filament with your purchase, we offer Big spools so you can make great use of the infinitive conveyor belt.
|Max. temperature||250 °C|
|Bed width||20 cm|
|Build Height||17 cm|
|3D printer properties|
Bowden printers feed filament through a tube as opposed to Direct Drive systems. This adds important advantages (faster printing) and disadvantages (higher filament retraction settings). You can find more information on Direct Drive and Bowden systems, Click here
|Max. heated bed. temp.||100 °C|
A SD Card in your printer will allow you to store prints and print them directly from SD. This is more reliable than a USB connection and allows you to power down your computer.
A heated bed is important to reduce Warping and have a better adhesion of the 3D print to the print bed.
Auto Bed Leveling
The auto bed leveling feature will probe the buildplate on a few different points. This allows the 3D printer to detect deviations in the buildplate and adjust the print accordingly. This makes is much easier to start a print as you don't have to manually adjust the bed position.
This feature allows your printer to be controlled over a WIFI network. You can execute movements as well as start a print.
This feature allows your printer to be controlled over a Ethernet network. You can execute movements as well as start a print.
|Filament sensor||Switch type|
|Input voltage||100-240 V|
|Operating voltage||24 V|
Replacement parts for the CR-30 Printmill, which may wear down over time.
CR-30 Printmill related products to keep you running.
Suggested improvements for your CR-30 Printmill.