Great for controlling higher currents
This board enables you to switch high currents (15A max) using a relay, as many 3D printer electronics is not able to provide these current safely.
This is a Do It Yourself (DIY) kit, please read the assembly guide.
Features
- Switch up to 24V and 15A
- Relay is controlled using 12V input (12V Min and Max)
- LED's indicate power and status
This kit comes with everything needed to assemble it.
This is a kit of the following items.
Quantity | Stock | Product |
---|---|---|
2x | Axial Carbon resistor - 180 Ω Ohm ±5 % 0.25 W - 10pcs | |
1x | Relay 12V, 30A | |
1x | LED - 5mm - Green | |
1x | LED - 5mm - Red | |
1x | Fuse 25A | |
2x | Fuse clip | |
2x | 2-way Screw terminal housing ( 16A ) | |
1x | Power relay PCB | |
1x | Diode 1N4004 |
Looking for a comparable product to the Power relay v1.0 DIY kit (low voltage version, max 24V)? Explore our selection of similar alternatives in place so that you always have a variety of options for any project. Feel free to reach out to us for advice on the alternatives.