PLA filament with a glittering effect available in 6 awesome colors: Ruby Red, Sapphire Blue, Emerald Green, Silver Lining, Onyx Black, Medal Gold. The effect is very good and the filament is just a easy to work with as normal filament, although we recommend at least a .4 nozzle. Check out the colors here
The documentation for the W1209 board has been updated. There was a correction in the installation schema.
We have added a large amount of new products. Our assortment of heated bed heating elements has doubled, adding 24V, 290mm and even a 40cm 240 silicon heater mat! In addition to this you may need to pickup up a solid state relay. Also we have added 20x20 slot covers in six colors.
For other (recently) added new product check out our new product section.
You can now add the ReprapWorld electronics boards directly into Arduino. Currently we support Megatronics, Ultratronics and the Anet A6 boards. You can find the instructions here.
Created by the RepRap-enthusiastic and experienced Gemstock3D team, this open-source extruder is a dependable addition to any FDM printer. Just add a Nema17 with sufficient power and you are ready to go!
Read more here