Miniature microswitch - 1m wire pre-soldered

 - Product Information
Microswitch pre-soldered onto a 1m wire, useful as endstop on axes within your 3D printer. The wire does not come with a connector, so you can cut it to the right size.
excl € 2.99
incl Log in 
Price breaks
1 - 4: excl € 2.99
5 - 9: excl € 2.84
10 - ...: excl € 2.69
Need a larger quantity? Contact our Sales department.

Product information

MICROSWITCHINCLWIRE

8719345000232

>100

Endstops

Documentation

Product description

Microswitch pre-soldered onto a 1m wire, useful as endstop on axes within your 3D printer. The wire does not come with a connector, so you can cut it to the right size.

This little 12.5x6x6mm microswitch can be easily mounted using two m2 screws. Note that you should make an afford to avoid repeated strain on the wire due to moving of the axes. The wires will break off easily, so make sure to fasten the wires as well. The wires are connected to the normally open and common pin of the endstop, so you should use the pull-up and invert endstop function of the firmware and connect the wires onto signal and ground. You can also use an external pull-up resistor of 10K between 5V and the signal pin to reduce effects of electrical noise.

Specifications

Dimensions

Wire length 100 cm
Price breaks
1 - 4: excl € 2.99
5 - 9: excl € 2.84
10 - ...: excl € 2.69
Need a larger quantity? Contact our Sales department.

Dimensions

Wire length 100 cm

About RepRapWorld
ReprapWorld

ReprapWorld is the number one webshop for all your reprap supplies for your 3D printer. We have a large collection of 3D printer components, from our famous electronics lines to filament from our own production. And everything is at a very competitive price!

Contact

RepRapWorld B.V.
Wagenmaker 6a
2631RL Nootdorp
The Netherlands

Email: info@reprapworld.com
Tel: +31 (0) 85 - 009 15 31

Copyright 2009 - 2018 | RepRapWorld B.V.