PVA

This material is only used as support material for PLA as it bonds well with PLA and is water soluble. It prints at 200 degrees and is translucent-brownish. For printing it behaves rather like PLA actually. If you put it in warm water for a while the material will slowly dissolve leaving you with only PLA. The material is rather expensive though, making it only applied in situations where you cannot go without support.

3D printer PVA filament


About RepRapWorld
ReprapWorld

This is the number one webshop for all your reprap needs. We have quite a lot of stuff, from electronics to filament. And everything is at a very competitive price!

Contact

RepRapWorld B.V.
Wagenmaker 6a
2631RL Nootdorp
The Netherlands

Email: info@reprapworld.com
Tel: +31 (0) 85 - 009 15 31

Copyright 2016 - RepRapWorld B.V.